Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. SUPPLIED ACCESSORIES – 1 X certified AC/DC adapter: OH-1018A0902000U-SAA (Input: 100-240V ~ 50/60Hz 650mA, Output: 9V – Docking kit •...
8 VOL+/- – adjusts the sound level 9 MUTE – switches playback sound off and on. 0 Display – shows clock/alarm times and status of the set ! Dock connector (30 pins) – connects iPod player ALM 2 – activates/confirm ALARM 2 time setting –...
Remote control Important! • Before using the remote control, remove the insulation plastic tab as shown in the figure. • If the remote control does not function correctly or the operating range is reduced, replace the battery with a new (CR2025) type battery.
BASIC OPERATION. Switching on the system • Press POWER. ™ The system will switch to the last selected source. • Press TUNER/AUX or DOCK. ™ The system will switch to the selected source. Switching the system to standby mode • In any source mode, press POWER. Switching off the volume temporarily Press MUTE on the remote control to stop sound play-back instantly.
TUNER 1 Press TUNER/AUX once to switch on the radio (FM only). ™ Display shows the radio frequency of the last selected waveband. Your pre- set station is also shown if you are listening to a preset. (See 2) 2 Adjust the sound using VOL+/-. 3 To select preset stations, press the respective PRESET button (1-5).
SETTING THE ALARM TIME (See 3) 1 In any mode, press and hold ALM1 or ALM2 for two seconds. ™ ALM1 / ALM2 icon and the hour digits flash. And the icon for the current alarm mode also flashes. 2 Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours. 3 Press ALM1 or ALM2 to confirm.
REPEAT ALARM This repeats your alarm call at 9 minute intervals. • During the alarm call, press REPEAT ALARM / ™ Display shows ALM1 or ALM2 flashing during a repeat alarm. • Repeat if desired (up to a maximum of 6 times). CANCELING THE ALARM COMPLETELY •...
PLAYING APPLE iPod USING AJ301D 1 Snap the compatible iPod into the dock connector. 2 Press DOCK to switch on the dock mode. 3 The connected player will play automatically. Notes: – In dock mode, if no player is docked for 15 minutes, AJ301D will come to standby. –...
Reset Should your set receive external interference e.g. static electricity from carpets, thun- derstorms, etc. RESET allows you to clear all previous settings and start up again. • Use a ballpoint pen to press the RESET hole found on the bottom of the set. CONNECTING AN EXTERNAL DEVICE You can listen to the sound of the connected external device through your AJ301D’s speakers.
Page 13
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Page 16
Docking Entertainment System Meet Philips at the Internet http://www.philips.com English AJ301D_UM_79_V3.1_1035...