Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips DCM230/55 User Manual

Radio Reception

Tuning to radio stations

1
Press SOURCE repeatedly (or TUNER on the
remote control) to select the tuner source.
2
Press BAND on the remote control to select
the desired waveband : FM or MW.
3
Hold / (or
S T
control) and then release the button.
➜
The system will start searching for a radio
station with sufficient signal strength.
4
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press
5 /6
on the remote control) briefly and
repeatedly until you have found optimal
reception.
18
iPod
TIMER
5 /6
on the remote
/ (or
S T

Programming radio stations

You can store up to a total of 20 radio stations
for each band in the memory.

Automatic programming

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press ALBUM/PRESET +/- (or ¡ / ™ on the
remote control) to select the preset number
where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG for more than two seconds to
activate programming.
➜
All available stations are programmed.

Manual programming

1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROG to activate programming.
➜
PROG flashes in the display.
3
Press ALBUM/PRESET +/- (or ¡ / ™ on the
remote control) to allocate a number from 1 to
20 to this station.
4
Press PROG again to confirm the setting.
➜
PROG disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.