Table of Contents
Advertisement
Available languages
Available languages
CHANGING LIGHT BULBS
Bielmeier extractor hoods are supplied with LED lights. Lightbulbs are wear parts and can be ordered from the
manufacturer on demand as spare parts.
However, the use of LEDs as workstation lights makes the need to replace defective lights highly unlikely. Service
life, reliability, and energy efficiency are significantly above those of conventional lightbulbs, such as halogen,
fluorescent tubes, etc. However, proceed as follows if the lights nevertheless fail:
Changing LED lightbulb
Pull power plug and/or disable circuit breaker!
In order to reduce dirt buildup in the hood interior, the LED spotlights for the workstation lighting are mounted
flush with the hood body.
1. Open the cover plate and remove the grease filter.
2. Now push the complete LED spotlight from the interior to the outside.
3. Disconnect the connector for the defective spotlight.
4. Connect the new spotlight with the connector.
5. Then gently push the spotlight back into the housing.
NOTE: If the lights fail to work, check whether the lights are seated properly. Defective lights should be replaced
promptly to avoid overloading the remaining lights.
Contact customer service if the lights do not work after the lightbulbs were replaced.
STARTUP – OPERATION
Operator panel - electronic control: BHG52, BHG53, BHG59, BHG58
Lighting
Output
Output Display
Controls
increase
on / off
The operator panel is located on the front of the equipment. It has a user-friendly design and is easy to operate.
12
Output
Dwell Timer
Operator
decrease
remotecontrol
Operator panel - electronic control: BHG41
Operator controls
Lighting
Remote control
on / off
Dwell timer
Output display
Operator panel - electronic control: BHG39, BHG93
Operator control
Blower on/off
Remote control
Output display
Output
Operator control / remote control
This unit can also be conveniently controlled with the included IR remote control:
Electronic control
Lights on/off
The lights are switched on or off by touching this control surface.
When
is touched (increase output)
a „5 or F5" is displayed in the output display. This means: the highest output level is automatically selected when
this control surface is pressed. The output level is continuously incremented up to the highest output level when
the control surface is depressed continuously.
GB
Output
Output
Blower
decrease
on / off
Dwell timer
Output
Lights
on/off
13
Advertisement
Chapters
Table of Contents
