Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for BIELMEIER KH 17101 E
Summary of Contents for BIELMEIER KH 17101 E
- Page 1 INSTRUCTIONS FOR USE Kitchen extractor hood Type: KH 17101 E, KH 17106 E...
-
Page 2: Table Of Contents
Dear Customer!! You are now a user of the newest generation kitchen extractor hood of KH 17101, KH 17106. This hood has been designed and manufactured specially with a view to satisfying your expectations and it will certainly constitute a fitting element of a modern kitchen. -
Page 3: I Characteristics
I. Characteristics Kitchen extractor hood KH 17101, KH 17106 was designed to remove kitchen fumes. It requires installation of a conduit discharging used air to the outside. The conduit (usually a pipe Ø150 mm) shall not be longer than 4-5 m. The hood can operate as an odour absorber after installation of an active carbon filter. -
Page 4: Iii Technical Data
III. Technical data Type Characteristic KH 17101 KH 17106 Supply voltage AC 230V 50Hz Fan motor Lighting Halogen lamps 2x20W Number of grease filters Fan speeds Width [cm] Depth [cm] Height [cm] 109 – 128 Outlet [ø mm] 150 bzw. 120 Capacity [m max. -
Page 5: V Installation
8. When connecting to 230V power supply network use an electric socket in working order. V. Installation To install the hood proceed as follows: 1. Install the wall hanger [B] at the appropriate level. 2. Hang the hood body [A] on the hanger [B] 3. -
Page 6: Installation Of The Wall Hanger
1. Installation of the wall hanger a) Trace a vertical line on the wall to indicate the center of the cooker plate, b) Hold a hood hanger profile [B] to the wall (Fig. 3, and 3), set it symmetrically in relation to the central line, with the distance between the holes in the profile and the cooker plate amounting to min. -
Page 7: Connecting To The Power Network And Operation Check
3. Connecting to the power network and operation check After connecting the device to the power supply network (in accordance with the requirements defined above) it is necessary to check the lighting of the hood and whether its motor works correctly. The wall socket shall be accessible for disconnecting the plug after the hood is installed. -
Page 8: Operation
Always make sure that flame does not extend outside the pot. Such a situation causes undesired energy losses and dangerous heat build-ups. The hood should not be used for other purposes than those for which it was designed. 2. Operation 2.1. -
Page 9: Maintenance
TIMER function has to be actuated within 20 seconds, otherwise the hood will return automatically to normal operation. The microprocessor system may get deleted or crash during momentary voltage drops in the network, and stop responding to commands from the keyboard. In such case the hood has to be disconnected from and then connected again to the power network in order to reset the system. -
Page 10: Lighting
3.3. Lights. The lighting system consists of two halogen lamps of 20 W power each. To replace a light bulb proceed as follows: a) Using a flat tool or screwdriver prise the ring holding the halogen lamp glass (Fig. 8) and, holding it, remove to the outside.
Need help?
Do you have a question about the KH 17101 E and is the answer not in the manual?
Questions and answers