Frymaster 3000 Replacement Manual

3000 Computer Field Replacement for OCF Models
The 3000 service computer ships with the latest software installed
and with an SD card for updating other 3000 computers on the fryer
bank. There are important assessments that have to be made to ensure
the service controller is properly set up for the fryer it is being
installed on and that it's in synch with the settings of the mounted controllers.

Ensure the fryer to get the controller is an OCF model. OCF fryer controllers are linked by an
orange CAN network cable and share data. Legacy fryers are not linked by a data cable.

Does the fryer have an automatic oil top-off system?

Is the fryer connected to a bulk oil or waste system?
The controller must be set to match the setup of the fryer and the other 3000 controllers on the fryer.
The service OCF 3000's default setup is: Fuel: Gas; Type: GL30 Full; Fresh Oil: JIB; Waste Oil:
None. Controllers in a CAN bus-linked system with mismatched settings will exhibit operational
errors.
Follow the steps in Section 1.5 in the provided manual to assess the settings of the leftmost
controller on an OCF fryer. Make a note of each setting. They will have to be transferred to the
service computer.
Follow the instructions on the following page to replace a 3000 controller and start the setup for a 3000
controller on an OCF fryer.
CONTROLLER
REPLACEMENT IS NOT
PLUG AND PLAY
Accurate setup is essential
6/14
*8197034*