Cleaning The Condenser Coil; Required Tools - True TBR Series Installation Manual

TRUE
TBR | TDR SERIES
MAINTENANCE, CARE & CLEANING

CLEANING THE CONDENSER COIL

When using electrical appliances, basic safety precautions should
be followed, including the following:
WARNING:
Do not clean appliance with a water jet or hose.
CAUTION:
Condenser coil fins are sharp.

REQUIRED TOOLS

• 1/4" nut driver
• 3/8" nut driver
• Stiff bristle brush
• Tank of compressed air
• Vacuum cleaner
• Flashlight
• Eye protection
– Disconnect power to unit.
STEP 1
– Remove the screw securing the louvered grill
STEP 2
to the cabinet.
– Tilt the top of the grill away from the cabinet.
STEP 3
The grill is held in place with magnets. Lift up
on the grill to release it from the bottom latch.
– Carefully clean off accumulated dirt from the front
STEP 4
fins of the condensing coil with a stiff bristle brush.
CAUTION FINS ARE SHARP. CAUTION MUST BE
USED TO AVOID EYE INJURY. EYE PROTECTION IS
RECOMMENDED.
– With dirt removed from the surface of the coil, use a
STEP 5
flashlight to verify that you can see through the coil and observe
the condenser fan blade spinning. If the view is still blocked with
dirt, refer to step 6. If the view is clear, reinstall louvered grill.
• Connect unit to power and verify operation.
(CONT.)
2
3
4
5
truemfg.com
19