Shure ANI22 Manual page 20

ANI22 Audio Network Interface
< GET xx AUDIO_OUT_CLIP_INDICATOR >
< REP xx AUDIO_OUT_CLIP_INDICATOR ON >
< REP xx AUDIO_OUT_CLIP_INDICATOR OFF >
< REP IP_ADDR_NET_AUDIO_PRIMARY {yyyyyyyyyyyyyyy} >
< GET IP_SUBNET_NET_AUDIO_PRIMARY >
< REP IP_SUBNET_NET_AUDIO_PRIMARY {yyyyyyyyyyyyyyy} >
< GET IP_GATEWAY_NET_AUDIO_PRIMARY >
< REP IP_GATEWAY_NET_AUDIO_PRIMARY {yyyyyyyyyyyyyyy} >
20/24
Command String:
< SET METER_RATE sssss >
ANI22 Response:
< REP METER_RATE sssss >
< SAMPLE aaa bbb ccc ddd >
Command String:
< SET METER_RATE 0 >
ANI22 Response:
< REP METER_RATE 00000 >
Command String:
< GET LED_BRIGHTNESS >
ANI22 Response:
< REP LED_BRIGHTNESS n >
Command String:
< SET LED_BRIGHTNESS n >
ANI22 Response:
< REP LED_BRIGHTNESS n >
Command String:
ANI22 Response:
Command String:
< GET IP_ADDR_NET_AUDIO_PRIMARY >
ANI22 Response:
Command String:
ANI22 Response:
Get Audio Gateway Address
Command String:
ANI22 Response:
Stop Metering
Get LED Brightness
Set LED Brightness
Get Audio Clip Indicator
Get Audio IP Address
Get Audio Subnet Address
Shure Incorporated
Where sssss is the metering speed in milliseconds.
Setting sssss=0 turns metering off. Minimum setting
is 100 milliseconds. Metering is off by default.
Where aaa, bbb, etc is the value of the audio level
received and is 000-060.
aaa = input 1
bbb = input 2
ccc = output 1
ddd = output 2
A value of 00000 is also acceptable.
Where n can take on the following values:
0 = LED disabled
1 = LED dim
2 = LED default
Where n can take on the following values:
0 = LED disabled
1 = LED dim
2 = LED default
Where xx is ASCII channel number: 00 through 04.
The ANI22 will respond with one of these strings.
Where yyyyyyyyyyyyyyy is a 15 digit IP address.
Where yyyyyyyyyyyyyyy is a 15 digit subnet
address.
Where yyyyyyyyyyyyyyy is a 15 digit gateway
address.
2017/10/10