Table of Contents
Advertisement
P3 allows you to enable
B, the settings for main, tremolo and gate can also be toggled. This would
allow you, for instance, to have setting A with 'tremolo turned on' and
setting B with 'gate enabled' and no tremolo etc... When
disabled, only one global setting is available and used for both A and B.
Turn P3 to zero to disable this mode.
Instrument-configuration Save / Recall:
Each selected Instrument has its own midi/instrument configuration
associated with and is collectively stored / recalled. When the Theremin
powers up, all stored (user) settings for all instruments are loaded.
When you change the settings during operation, the changes will be lost after
power down, unless they are collectively saved before power down. This
way, you will always have a defined setting after power up and don't have to
worry, when fiddling with the knobs.
Just make sure before you save a new setting, you are happy with it. If not,
you can always recall the currently stored user setting or the default setting,
modify as required and then store this as your new user setting.
Save user settings: To save current settings as user settings, set the
instrument-selector to
user'. The red status LED will flash fast. Push the trigger button for more
than one second to 'accept'.
Recall Settings: To recall default settings or user settings, set the
instrument-selector to
default'
or
'load
button for a short time to 'accept'.
'Global
A/B'. When toggling between setting A and
'SETUP'
and then set the mode-selector to
'SETUP'
and then set the mode-selector to
user'. The red status LED will flash fast. Push the trigger
'Global A/B'
is
'save
'load
22
Advertisement
Table of Contents
