Making The First Sounds With The Wave-Theremin - Horst MIDI Wave-Theremin MWT-01 Manual

Making the first sounds with the Wave-Theremin:

Initial Setup:
• Make sure the amp is working
• Point the Wave-select knob (INSTRUMENT) to
• Set the Mode-knob (GLOBAL) to position 'Main'.
• Make sure the
• the 'Auto-Retune'
• Turn all 3 potentiometer knobs (Volume,Tone,Octave) to 12 o'clock
(you need to actually move the knobs to "unlock" them)
• You should be hearing some sound when approaching the Theremin
antenna (20 ... 30 cm).
• If not, try to push the
• make sure the "Gate" is disabled (see Gate)
No sound yet ? If you can't hear anything yet, try to use the build in tuner
to generate a sound (Sine-wave at approx 440 Hz) :
• Point the Wave-select knob (INSTRUMENT) to
• The red status LED is now flashing fast.
• Set the Mode-knob to position
• Adjust the volume of the tuner.
• You should be hearing a sine-wave 440 Hz
• You can 'fine-tune'
Still no sound yet ? Is the Amp turned ON ? Audio lead buggered ?
Antenna Retune: To retune the antenna during use
• Point the Wave-select knob (INSTRUMENT) to
• The red status LED is now flashing fast.
• Set the Mode-knob to position
• Push the red
• Step back and wait for tuning to finish
• Check tuning (you should hear a sine wave when approaching the
Theremin antenna (20 ... 30 cm).
'Mute' switch is in the UP position (audio on) and
switch is in the UP position too.
'Trigger'
'Pitch'
the oscillator frequency with the 'Tone' knob
'Auto-Tune'
'Trigger' button next to the LED
'Sine'
button next to the LED
'SETUP'
(MIX).
'SETUP'
(GLOBAL).
and
9