Table of Contents
Advertisement
Midi Setup: To setup various midi options, set the mode selector to
setup'
(vol) and push the trigger button.
P1 allows you to select a global
every channel increment will send a note-off/note-on "click" message to the
midi output. Turn P1 to zero to set channel to zero (default).
P2 allows you to customize the 'Pitch-bend-mode'. Adjusting P2 will send a
note-off/note-on message and a pitch bend message to the midi output. Turn
P2 to zero (default) to set to Theremin-mode (return pitch-wheel to low
position). All other modes will return pitch-wheel to center position. See
Pitch-bend-mode for other options.
P3 (
'Instrument Select / OFF'
of "click" messages. When adjusting midi parameters in SETUP, every
increment of a parameter will send a note-off/note-on "click" message to the
midi output. With P3, you can choose the "Instrument" for the "click"
message (i.e. piano). Turn P3 to zero to turn off the sending of "clicks".
Other Setup: To setup "other" midi options, set the mode selector to
setup'
(tone) and push the trigger button.
P1 allows you to enable
output (not midi) will not be effected by tremolo or gate and will always (!)
be audible. This is useful when operating midi devices. The audio output can
then be used as a cue (via headphones) before triggering the midi note. Turn
P1 to zero to disable this mode.
P2 allows you to enable
Theremin without your hand being in the "active region" of the antenna, a
note-off/note-on midi message is only send when
enabled . Turn P2 to zero to disable this mode.
Hint: Enable
'always-trigger'
'midi channel'
) allows you to adjust or disable the sending
'midi monitor
mode'. In this mode, the "audio"
'always-trigger
mode'. When triggering the midi
when using the theremin as a finger drum.
(1 .. 31). When adjusting P1,
'always-trigger mode'
'midi-
'other-
is
21
Advertisement
Table of Contents
