Tape Player - Aiwa CSD-AM700 Operating Instructions Manual

Troubleshooting (continued)

Tape player

The tape does not move when you press
an operation button.
• Close the tape compartment securely.
The REC z button does not function.
• Make sure the safety tab on the cassette is in
place.
The tape does not erase completely.
• Clean the erase head (see page 33).
• Replace all the batteries with new ones if
they are weak.
• The source which was recorded on a TYPE II
(high position) or TYPE IV (metal) tape
using this unit is being played. Record on
TYPE I (normal) tapes and play.
The tape does not record.
• Make sure the tape is inserted properly.
• Make sure the safety tab of the cassette is in
place.
The audio is weak.
The audio quality is poor.
• Clean the heads, pinch roller and capstan (see
page 33).
• Demagnetize the heads using a demagnetizer
(see page 33).
The sound is distorted.
• A TYPE II (high position) or TYPE IV
(metal) tape is being used. Use TYPE I
(normal) tapes only.
Timer
The timer/alarm does not operate.
• Make sure the time on the clock is correct.
• Check to see if the AC power had been cut
off.
• Make sure the "
indication is displayed.
GB
32
" (timer) or " " (alarm)
Remote
The remote does not function.
• Replace all the batteries in the remote with
new ones if they are weak.
• Make sure that you are pointing the remote at
the remote sensor on the player.
• Remove any obstacles in the path of the
remote and the player.
• Make sure the remote sensor is not exposed
to strong light such as direct sunlight or
fluorescent lamp light.
• Move closer to the player when using the
remote.