Aiwa CSD-AM700 Operating Instructions Manual page 61

To check/change when the
playback/alarm will start
Press ALARM/TIMER until the hour digit
flashes in the display, then press DISPLAY/
ENTER. Each time you press DISPLAY/
ENTER, a stored setting is displayed in the
set order.
To change the setting, display the setting you
want to change and re-enter it.
To use the player before the
timer playback/alarm starts
Just turn on the player, and you can use it.
After using the player, set the function
switch to the same position as you set it in
step 2, then turn off the player.
If you turn off the player before the preset
time, the timer playback/alarm will start at
the preset time.
In case of the radio, however, if you listen to
the station that is different from the one you
tuned in step 3, you will hear that different
station at the preset time. Make sure to tune
in the station you want to listen to before
you turn off the player.
To cancel the timer/alarm
standby mode
Press ALARM/TIMER twice so that the
timer/alarm indication disappears.
To restore the standby mode, press the
button again.
To turn off the timer/alarm
Press POWER to turn off the player.
To doze for a few more minutes
Press SNOOZE.
The power goes off and the player turns on
automatically after about 5 minutes. You can
repeat this process up to 6 times by pressing
SNOOZE.
If you press the button at the seventh time,
the power goes off.
To cancel the snooze function,
press ALARM/TIMER while the snooze
function is activated.
Note
Do not try timer playback of a tape or timer
recording. Doing so causes the player to
malfunction or damage to the tape.
Tips
• The alarm generates beep sound for a duration of
about 5 minutes.
• Note that if timer playback mode is changed to
alarm mode (and vice versa) by resetting the
function switch while the power is off, the timer/
alarm indication in the display will not change.
GB
25