Advertisement
Quick Links
Refer to YAKIMA Control Tower instructions for important warning and load limitations, and YAKIMA's limited warranty.
RECOMMENDED TOOL:
Measuring Tape
BEFORE YOU BEGIN:
It is recommended
that you remove the
factory crossbars.
For removal, refer to your
vehicle owner's manual.
1033030A-1/6
Landing Pad #3
TO REMOVE FACTORY-INSTALLED RACKS:
• Open rear hatch door.
• Pry up the track cover-plate.
You may need to remove
your vehicle's factory
crossbars and slats.
Check to see if Landing
Pad location will cause
interference. Refer to
your vehicle's owner's
manual for details on
factory rack removal.
• Pushing tower lever
open, slide vehicle's
crossbar off.
Part #1033030 Rev A
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Yakima Landin Pad 3
Summary of Contents for Yakima Landin Pad 3
- Page 1 Landing Pad #3 Refer to YAKIMA Control Tower instructions for important warning and load limitations, and YAKIMA’s limited warranty. You may need to remove your vehicle’s factory crossbars and slats. Check to see if Landing Pad location will cause interference. Refer to your vehicle’s owner’s...
- Page 2 CROSSBAR SPREAD: interference with your load would be before accessories is unavoidable. The distance between the Yakima completing the installation. crossbars is determined by the accessories you wish to carry. LOAD LIMITS: Limit your loads to...
Need help?
Do you have a question about the Landin Pad 3 and is the answer not in the manual?
Questions and answers