Indicating And Control Elements - Dräger REGARD 2400 Instructions For Use Manual

5.

Indicating and Control Elements

18
Power
F1
1
F1
F2
Reset
LED Power (green)
LED Horn (red)
LED Error (yellow)
LED A to D (red)
LED x10 (green)
3-pin connector
Press F2 button
The following configuration applies for all measuring channels:
— One relay each for common alarm and horn
— One button for horn and alarm reset
— Alarm memory is integrated
— LEDs indicate the operating
The Dräger REGARD 2400 / 2410 provides a scrolling display.
The RS232 interface is for the configuration of the Dräger REGARD 2400 / 2410 via PC/Lap-
top.
Reset
Channel A B C D
Concentration
F2
REGARD 2410
Set Inhibit Mode (see "Menu" on page 44)
Hold current channel;
Watch configuration (see "Configuration-Information-Menu" on
page 46)
Reset horn and alarm, leave Inhibit mode
Supply voltage present
Horn
Fault
Alarm
Multiply displayed value by10 for actual gas reading
Interface RS232
Stop display scrolling
Indicating and Control Elements
x10 Horn Error
A2
A1
A B C
D
35
17
31