42Gps:sastat:kdp; 43Gps:sastat:antispoof; 44Gps:sastat <Int> [0,255] - Jackson Labs RSR GNSS Transcoder User Manual

RSR GNSS Transcoder™ User Manual
This command only works with an external Rockwell Collins MicroGRAM or RSR Puck.
4.10.42 GPS:SASTAT:KDP?
This query displays the KDP Health Status using the values in the following table:
This command only works with an external Rockwell Collins MicroGRAM or RSR Puck.
4.10.43 GPS:SASTAT:ANTISpoof?
This query displays the Anti-Spoof Status using the values in the following table:
This command only works with an external Rockwell Collins MicroGRAM or RSR Puck.
4.10.44 GPS:SASTAT <int> [0,255]
This command instructs the RSR GNSS Transcoder™ to send the $SASTAT proprietary NMEA
output sentence every N seconds, with N in the interval [0,255]. The command is disabled during the
initial oscillator warm-up phase. This command has the following format:
GPS:SASTAT <int> [0,255]
The $SASTAT output gives all status information from all of the DAGR and SAASM-related queries
described in Sections
$SASTAT,hhmmss.sss,aa,b,c,d,e,f,g,h,i,j,k*[checksum]
Where:
hhmmss.sss: Current UTC Time at the start of the previous second
aa: Number of Satellites in Y-Code Track
b: CV Zeroize Status
c: CV Status
d: CV Fill Status
e: Verification Status
f: CV Expiration Status
g: KDP Health Status
h: Anti-Spoof Status
i: DAGR Transfer Status
82
Value
0 Alive
1 Dead
Value
0 OK
1 Error
4.10.32 through 4.10.43 . The $SASTAT command has the following format:
Status
Status
© 2017 Jackson Labs Technologies, Inc.