9Ptime:leapsecond:duration; 10Ptime; System Subsystem; 1System:communicate:serial:echo - Jackson Labs RSR GNSS Transcoder User Manual

RSR GNSS Transcoder™ User Manual
4.12.9 PTIMe:LEAPsecond:DURation?
This command returns the duration of the last minute of the day during a leap second event. The
returned value is 59, 60 or 61 if GPS Almanac data is available, and 0 otherwise. A response of 60
indicates that no leap second is pending.
4.12.10 PTIME?
This query returns the result of the following queries:
PTIME:DATE?
PTIME:TIME?
PTIME:TINTerval?
PTIME:OUTput?
PTIME:LEAPsecond:ACCumulated?

4.13 SYSTEM Subsystem

This subsystem groups the commands related to the general configuration of the RSR GNSS
Transcoder™. The list of the commands supported for this subsystem follows:
SYSTem:COMMunicate:SERial:ECHO <ON | OFF>
SYSTem:COMMunicate:SERial:PROmpt <ON | OFF>
SYSTem:COMMunicate:SERial:BAUD <9600 | 19200 | 38400 | 57600 | 115200>
SYSTem:FACToryreset ONCE
SYSTem:ID:SN?
SYSTem:ID:HWrev?
SYSTem:STATus?
4.13.1 SYSTem:COMMunicate:SERial:ECHO
This command enables/disables echo on the serial port. Echo should be turned off when using the
Z38xx application program. This command has the following format:
SYSTem:COMMunicate:SERial:ECHO <ON | OFF>
4.13.2 SYSTem:COMMunicate:SERial:PROmpt
This command enables/disables the prompt "scpi>" on the SCPI command lines. The prompt must be
enabled when used with the software GPSCon. This command has the following format:
SYSTem:COMMunicate: SERial:PROmpt <ON | OFF>
92 © 2017 Jackson Labs Technologies, Inc.