Output Subsystem; Output:test - Jackson Labs RSR GNSS Transcoder User Manual

RSR GNSS Transcoder™ User Manual

4.5 Output Subsystem

The commands in the OUTPUT subsystem control various features of the GPS RF and 10MHz
output, as well as the built-in RF synthesizer functionality.

4.5.1 OUTput:TEST

This command enables the test signal mode on the SMA RF output that can be used for calibration,
spectrum analyzer tests, RF front-end testing, or as a jamming test signal. The signal amplitude of the
test signal can typically be set up to -85dBm. The RF power level is set with the OUT:POWer
command.
The format of this command is:
OUTput:TEST <OFF|SWEEP|TONE|TWOTONE|RAND>
The following table describes each of the test modes:
60 © 2017 Jackson Labs Technologies, Inc.