Mounting The Base Unit - Bench; Mounting The Base Unit - Wall - Oregon 520-120 Instruction Manual

520-120
PREPARING FOR USE
ATTENTION Do not install the machine at eye level You are recommended to install it at a height of no
more than 3 9 to 4 2 feet (1 2 – 1 3 m) from the floor The machine can be bench mounted or wall mounted
MOUNTING THE BASE UNIT – BENCH
BENCH MOUNTING
Use two (2) appropriate bolts complete
with washers and nuts (not supplied),
inserted in the securing holes Make sure
you position the base unit hanging over the
edge of the bench as shown in the detail
MOUNTING THE BASE UNIT – WALL
NOTE: assemble the upper housing / motor unit (A) to the base unit (B) before mounting to your wall
SECURING THE UPPER HOUSING / MOTOR UNIT
Insert the bolt (K) in the dedicated hole (9) in
the motor unit (A) and through the mounting
slot (14) in the base unit (B) Insert the washer
(L) at the back and tighten the locking nut (I)
NOTE: you may need to depress the upper
housing to ensure correct alignment
NOTE: motor unit will need to be
adjusted by loosening and tightening
nut with a wrench (not supplied)
SECURING THE UPPER HOUSING / MOTOR UNIT
Insert the bolt (K) in the dedicated hole (9) in
the motor unit (A) and through the mounting
slot (14) in the base unit (B) Insert the washer (L)
at the back and tighten the locking knob (J)
NOTE: you may need to depress the upper
housing to ensure correct alignment
WALL MOUNTING
Use two (2) appropriate bolts
complete with washers (not supplied),
inserted in the securing holes
PREPARING FOR USE
13