Eaton LUMARK Crosstour MAXX Installation Instructions Manual

IB514002EN
Installation Instructions - Crosstour MAXX Emergency Egress
Option
Instructions d'installation - Luminaire Crosstour MAXX avec option
de secours
Instrucciones de instalación - Opción para Salida de Emergencia de
Crosstour MAXX
WARNING
Make certain power is OFF before starting installation
or attempting any maintenance.
WARNING
Make certain power is OFF before starting installation
or attempting any maintenance. Risk of fire/electric
shock. If not qualified, consult an electrician.
WARNING
Risk of Electric Shock—Disconnect power at fuse or
circuit breaker before installing or servicing.
WARNING
Risk of Burn—Disconnect power and allow fixture to
cool before servicing.
IMPORTANT: Read Before Installing fixture. Retain for Future Reference.
IMPORTANT SAFEGUARDS: When using electrical equipment, basic safety precautions should always be observed
including the following.
SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
1. Do not mount near gas or electric heaters.
2. Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or
eyes, flush acid with fresh water and contact a physician immediately.
3. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
WARNING
DO NOT mount luminaire within 6" of a combustible
surface. DO NOT handle luminaire by the lens.
WARNING
Risk of Personal Injury— Fixture may become
damaged and/or unstable if not installed properly.
Tighten all fixture components to their recommended
torque values. Do not lift pole into place by securing
lifting device to lighting fixture or mounting arm.
N ote: These instructions do not claim to cover all
details or variations in the equipment, procedure,
or process described, nor to provide directions
for meeting every possible contingency during
installation, operation or maintenance. When
additional information is desired to satisfy a
problem not covered sufficiently for user's purpose,
please contact your nearest representative.
N ote: Specifications and dimensions subject to change
without notice.
Brand Logo
reversed out of
black
INS # INS #