Cmos Clear (Jp7/Jp8); Power Button (Sw1); Power On/Bios Recovery Selection (Sw2) - WinSystems SYS-ITX-N-3800 Product Manual

v1.0

8.3.14 CMOS Clear (JP7/JP8)

Clear CMOS using this jumper (JP7/JP8). See "Reset CMOS BIOS
Configuration" on page 33 for usage of this jumper.
JP7/JP8
1-2 Short
2-3 Short

8.3.15 Power Button (SW1)

The power button (SW1), located on the upper right of the embedded
computer, controls power to the SYS-ITX-N-3800. The first time you
connect power to J1 or J12, the power button is bypassed and the
embedded computer powers up automatically.
After the initial power up, press SW1 briefly to power the unit on or off,
depending on the present state.
If the unit accidentally locks up and is unresponsive, press and hold SW1
for four (4) seconds to perform a hard restart.

8.3.16 Power On/BIOS Recovery selection (SW2)

Select the appropriate Power On/BIOS Recovery setting using these
switches (SW2).
SW2
1-4 OFF
1-4 ON
2-3 OFF
2-3 ON
www.winsystems.com
1
Function
Normal Operation (Default)
Clear CMOS Contents
4
ON
1
Function
ATX (Default)
AT
Recovery Disable (Default)
Recovery Enable
SYS-ITX-N-3800/Configuration
3
2
Page 20