olympia electronics GR-8/leds Installation Instructions

NON MAINTAINED / MAINTAINED EMERGENCY LUMINAIRES
TECHNICAL CHARACTERISTICS (
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES (Ni-Cd)
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
ILLUMINATION SOURCE
ILLUMINATION (230V AC / emergency)
DEGREES OF COVER PROTECTION
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
Thank you for your trust in our products.
Olympia Electronics - European manufacturer.
GENERAL
These luminaires are used indoors (ta 40 C)
on the wall, where emergency light is needed.
E a c h l u m i n a i r e m u s t b e p e r m a n e n t l y
connected to mains power supply. In normal
operation the illumination LEDs are lit as well
as the green indicating charge LEDs, when
the battery is charging.
In case of a mains power supply failure the
luminaire will light the led strip automatically
in emergency mode. When the mains power
supply is restored the device turns to normal
operation.
Non Maintained / maintained operation
there is an option to select the non maintained
or maintained operation by placing the jumper
to the appropriate place according to the
figure 3 (see page 2).
INSTALLATION
To install the luminaire follow the installation
instructions on page 2.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personnel
only.
2. The device must be connected to the
mains power supply through a fuse dependent
by the total amount of the line's power load.
3. It is suggested to check every month the
indication LED for battery charging, and by
pushing the TEST button to check the
Page 1 from 3
)
for led module spcifications see page 2
GR-8/leds GR-9/leds
220-240VAC/50-60Hz
2.7W/3VA 3W/3.5VA
3.6V/0.6Ah 3.6V/1Ah
Battery charge indication LEDs, TEST button
24 h
1.5 h 3 h
12 white LEDs
40lm / 100lm 38lm / 100lm
IP 42
o
5 to 40 C
Up to 95%
Bayblend FR3010, transparent polycarbonate
240 x 90 x 44 mm
345gr. 350gr.
3 years (1 year for the battery)
emergency circuit. The led strip should light as
o
long as the TEST button is pressed.
luminaire doesn't work as described above
contact the installer.
4. It is suggested to check every 6 months the
m i n i m u m a u t o n o n o u s d u r a t i o n b y
disconnecting the mains power supply. Count
the time that the led strip lights and in case of
less time than the nominal autonomy, the
battery must be replaced. If the measured time
i s c o n s i d e r a b l y l e s s t h a n t h e n o m i n a l
autonomy contact the installer. In case of
battery or led strip replacement, these must be
replaced by parts of the same type, by the
manufacturer or by a competent person.
5. In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery's connector.
6. I s not allowed to discard batteries in to t i
common trash bins, they must be
discarded only in battery recycling
points. Do not incinerate.
The light source contained in this
luminaire shall only be replaced by the
manufacturer, or his agent, or a similar
qualified person.
NOTE! The light source is non-user
replaceable.
923378005_09_008
If the