Download And Install Portvision Dx; Programming The Ip Address - Comtrol IO-Link Master Series Initial Installation And Configuration

Download and Install PortVision DX

You can use this procedure to download and install PortVision DX.
1. Download PortVision
2. Execute the PortVision_DX_x.xx.msi file, where x.xx is the version number.
3. Click Next to start the installation.
4. Click I accept the terms in the License Agreement and Next.
5. Click Next to install in the default location or browse to another location and then click Next.
6. Click Next to continue the installation.
7. Click Install. Depending on your operating system, you may need to click Yes to the Do you want
to allow the following program to install software on this computer User Account Control popup
message.
8. Click Finish.
PortVision DX is installed and you can use the next subsection to program the IP address into the IOLM.

Programming the IP Address

Use the following procedure to program the IP address into the IOLM using PortVision DX.
Note: Connect a single IOLM at a time because they all have the same default IP address. PortVision
DX cannot program an IP address in cases where there are multiple IOLMs with the same IP
address.
1. 4-EIP: Optionally, you can use the web interface to configure or Rotary switch to configure the IP
address. The Rotary switch settings override the lower 3 digits (8 bits) of the static IP address
configured in PortVision DX or the Configuration | Network page.
2. Start PortVision DX by using the desktop icon or click PortVision DX in the Start menu.
3. Depending on the
operating system, you
may need to click Yes to
the Do you want to allow
the following program to
make changes on this
computer User Account
Control popup message.
4. Click the Scan button to
locate your IOLM or
IOLMs on the network.
5. Click the hardware types
that you want to locate
and click Scan.
3/27/2015
Comtrol IO-Link Master Initial Installation and Configuration
DX.
P a g e | 9