Advertisement
Quick Links
Models:
CFX-36T
&
REFRACTORY AND GRATE:
To place the refractory into the
unit first make sure the bend up
tabs are all at 90° angles. Place
the refractory on the four largest
bend tabs.
The refractory should sit against
the front surround of the unit
and under the smaller back
tab(s). See Figure 1.
The grate is now placed onto
the refractory with the back legs
resting inside the location tab(s).
See Figure 2.
If this is not done the unit will not
function properly. The grate
should look centered in the unit
and on the refractory.
LOG PLACEMENT:
NOTE: Carefully remove logs from
the cardboard used in shipment.
Use caution, fiber logs are ex-
tremely fragile.
FRONT VIEW
CFX-DA
Figure 1.
Figure 2.
OVERHEAD
VIEW
REFRACTORY, GRATE and
LOG PLACEMENT INSTRUCTIONS
MAKE SURE THE GRATE IS ON THE
SMALL BACK BEND TABS.
1
2 3
1
4 5 6
492-925-D 1/99
Advertisement
Related Manuals for Hearth & Home CFX-36T
Summary of Contents for Hearth & Home CFX-36T
-
Page 1: Log Placement Instructions
Models: REFRACTORY, GRATE and CFX-36T CFX-DA & LOG PLACEMENT INSTRUCTIONS REFRACTORY AND GRATE: To place the refractory into the unit first make sure the bend up tabs are all at 90° angles. Place the refractory on the four largest bend tabs. - Page 2 LOG NUMBER 1: CFX-36T: Place Log #1 towards the back of the grate and pull it up to the two tabs. Make sure the detents on the bottom of the log fit into place over the grate. CFX-DA: Place Log #1 towards the back of the grate and push back against the firebox.
- Page 3 LOG NUMBER 4: Place the bottom of log #4 in the inside corner of the second grate arm from the left. Lay the top of the log (burned-out area) in the nesting slot on the right side of Log #1. LOG NUMBER 5: Place log #5 in the inside corner of the right side of the middle grate arm.