– Make sure to complete the
preparation procedures before operating
Step 1: Inserting batteries into
the remote control
Open the battery compartment.
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by "+" and "–" symbols.
Close the cover.
Using the remote control to operate the
system (It is only available in disc mode)
Adjust the source switch to
Point the remote control directly
at the remote sensor (IR) on the
Then select the desired function
– Remove batteries if they are
exhausted or will not be used for a long
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the TV set
– Make sure you have completed all the
Push the source switch to disc mode.
Turn on the TV set and set to the correct Video-
In channel. You should see the blue Philips DVD
background screen on the TV set.
➜ You may go to channel 1 on your TV set, then
press the channel down button repeatedly until
you see the Video In channel.
➜ Or, you can use the TV remote control to
select different video modes.
➜ Or, set TV to channel 3 or 4 if you are using
an RF modulator.
Selecting the color system that matches
your TV set
This DVD Soundmachine is compatible with
both NTSC and PAL. For the playback of a DVD
disc on this DVD Soundmachine, the color
systems of the DVD, TV set and DVD
Soundmachine should match.