Preparations; Step 1: Inserting Batteries Into The Remote Control; Step 2: Setting The Tv Set - Philips AZ5738 User Manual

Preparations

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
3
1
2
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by "+" and "–" symbols.
3
Close the cover.
Using the remote control to operate the
system (It is only available in disc mode)
1
Adjust the source switch to
DVD/VCD/CD grade.
2
Point the remote control directly
at the remote sensor (IR) on the
front panel.
3
Then select the desired function
S T
(for example ,
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
10
or )
II

Step 2: Setting the TV set

IMPORTANT!
– Make sure you have completed all the
necessary connections.
1
Push the source switch to disc mode.
2
Turn on the TV set and set to the correct Video-
In channel. You should see the blue Philips DVD
background screen on the TV set.
➜ You may go to channel 1 on your TV set, then
press the channel down button repeatedly until
you see the Video In channel.
➜ Or, you can use the TV remote control to
select different video modes.
➜ Or, set TV to channel 3 or 4 if you are using
an RF modulator.
Selecting the color system that matches
your TV set
This DVD Soundmachine is compatible with
both NTSC and PAL. For the playback of a DVD
disc on this DVD Soundmachine, the color
systems of the DVD, TV set and DVD
Soundmachine should match.