Table of Contents
Advertisement
To pair a heart rate sensor with Polar Beat:
1.
Wear
the sensor.
2. Open Polar Beat app on your Android or iOSdevice.
3. Go to the settings section of the app and find HR sensor. When your sensor is found, tap PAIR.
Note that the H9 transmits your heart rate signal simultaneously via Bluetooth and ANT+. You can turn off the
ANT+ transmission from the Beat settings under HR sensor.
PAIR WITH A POLAR WRIST UNIT
You need to wear the sensor when pairing it.
Check the user manual of your Polar wrist unit at
USING YOUR HEART RATE SENSOR IN WATER
Polar H9 heart rate sensor is water resistant. The GymLink technology can be used in water activities, but
Bluetooth® wireless technology will not work in water. Please notice that sea and pool water are very conductive,
and electrodes may short-circuit, preventing ECG signals from being detected by the heart rate sensor.
When using a bathing suit, the best performance is achieved by wearing the heart rate sensor underneath it.
FIRMWARE UPDATE
With the Polar H9 heart rate sensor, we'll be able to bring updates to your sensor to improve it or even bring new
functionalities to it. You'll be able to update the firmware via the Polar Beat or Polar Flow mobile app.
To receive the firmware updates, your H9 heart rate sensor needs to be paired with the Polar Beat or Polar Flow
app, Android or iOS. The app will let you know if there's an update available and will guide you through it.
Sensor pairing is needed after update / battery replacement, if you use H9 with Polar A360, M400, A300, M450,
V650, M200, M600, Vantage M, Vantage Vor 3rd party app / device.
CARING FOR YOUR HEART RATE SENSOR
The heart rate sensor is a high-tech instrument that should be handled with care. Follow the caring instructions to
ensure reliable measurement and to maximize the life span of the heart rate sensor. The following instructions will
help you fulfill guarantee obligations.
Connect or: Detach the connector from the strap after every use and dry the connector with a soft towel. Clean the
connector with a mild soap and water solution when needed. Never use alcohol or any abrasive material (e.g. steel
wool or cleaning chemicals).
support.polar.com
for specific pairing instructions.
See instructions.
6
Advertisement
Table of Contents
