Advertisement
Available languages
Available languages
5.4. Mounting
The filter is designed for underwater use only. The max. submergence is 1 m. In any case, dry
running of the pump has to be avoided.
The holding plate (7) with the rubber suckers (8) can be connected with the pump from 2 sides.
The pump head (2) can be fitted to the motor (1) in 2 ways, so the outlet can be adjusted. A
further possibility to direct the water flow is using the 45° elbow. If aeration is desired, the air
injection nozzle can be mounted.
Safety advice:
The pump is constructed for indoor use only. Before working on the aquarium or
pump, always disconnect the device from the mains. The connection cable and the
power plug may not be changed. If the power cable is damaged, the pump may not be
used any more. After setting up the pump, make sure you can always reach the
power plug.
5.5. Maintenance/Cleaning
The filter sponge has to be cleaned from time to time, depending on water conditions. In order to
protect the bacteria population, the sponge should be rinsed in hand warm water, the best is
aquarium water.
Depending on water quality, the pump has to be cleaned from time to time. Pull out the power plug
before you start any work at the pump. Remove the pump housing. Now, the complete rotor (9 -
11) can be removed, cleaned under running water and reassembled in opposite order.
5.6. Failures
The pump is constructed for long term maintenance-free operation. In case the pump is creating
noise, the complete pump has to be cleaned. In case the impeller or magnet is damaged, the whole
rotor has to be replaced.
6. Lighting system 2 x Ocean Light 36 watts
6.1. Technical Data
Power requirements: 100 - 240 V AC, 50 - 60 Hz.
- 3 watts Cree high-performance LEDs
- light efficiency approx. 120 Lumen/watts
- colour temperature 14,000 K
- durability of the LEDs – according to manufacturer's data – 50,000 hours
- safety voltage 24 V with external power pack
Version:
- Ocean Light LED 36 watts (4 x 3 watts blue and 8 x 3 watts 12,000 K)
Dimensions (l x w x h): approx. 600 x 120 x 25 mm
The body is made of anodized aluminium. The cooling is done passively.
6.2. Unpacking
Control the lighting system immediately after unpacking with respect to any damages. In case of
complaints, please contact your dealer directly.
Included in shipment:
Ocean Light LED incl. power pack 24 VDC output
•
Aquaria fixing
•
21
Advertisement
