Managing Modems In Routing Or Bridging/Routing Mode - ADC 410F User Manual

Managing Modems in Routing or Bridging/Routing Mode

The following is a sample configuration for setting the IP addresses and subnet masks when
only routing mode or both routing mode and bridging mode are enabled. Note that there must
be three IP subnets: 410F LAN, 420F LAN, and the 410F to 420F ADSL (WAN). When you
connect to a modem either locally or remotely, use either the modem 10/100BASE-T LAN port
or ADSL (WAN) port IP address, respectively.
The IP addresses in the figure below are for example only. Acquire your own
IP addresses from your network administrator or service provider.
192.168.0.10
255.255.255.0
192.168.0.11
255.255.255.0
192.168.0.9
255.255.255.0
420F LAN IP Subnet
The default IP address for the 10/100BASE-T LAN port is 192.168.0.1 and the IP subnet mask
is 255.255.255.0. If you want to view or change the default IP address for the modem, see
"Using the RS-232 management Port for Set Up" on page 24
Megabit Modem 410F and 420F User Manual
420F
Modem
ADSL
192.168.0.4
255.255.255.0
192.168.10.4
255.255.255.0
WAN IP Subnet
Chapter 4: Setting Up for Configuration
192.168.20.5
255.255.255.0
410F
Modem
192.168.10.2 192.168.20.1
255.255.255.0 255.255.255.0
410F LAN IP Subnet
for instructions.
192.168.20.6
255.255.255.0
23