Set Up The Remote Control - Fantasia Elite Zeta Owner's Instruction Manual

6. SET UP THE REMOTE CONTROL

IMPORTANT : DC MOTOR INITIAL SETUP PROCEDURE.
O N ECE
1 2 3 4
NOTE:
If the power is interrupted or turned off by a wall switch, the fan will run
through an automatic set up procedure. The fan will start to run at high speed for
approximately 120 seconds, then drop to the speed you have pushed on the
transmitter or the speed that it was set to before power was disconnected.
THIS STEP MUST BE PREFORMED BEFORE
YOUR FAN WILL OPERATE
1. Set the dip switches with different code
which is at inside the battery compartment
door of the hand set transmitter if you have
more than one set fan to be operated at same
room.
2. Within 60 seconds of turning power on to the
unit, press the "SET" button (also inside the
battery compartment door) for 5 seconds or
until the lights blink twice.
3. Press Button 6 (High Speed) button and let
the unit run for 120 seconds. This is
necessary for the electronics to calibrate
each speed/RPM based on the load of the
blades.
4. After 120 seconds, reverse the fan and press
Button 6 (High speed) button in the upflow
direction to accomplish the same endeavor.
5. 5.After the above 4 steps are completed the
fan should be ready to operate normally at
any speed.
6. The dip switch "D" and "ON" is for setting up
the operation of the light kit. In the 'ON'
position the dimmer will operate. In the 'D'
position the light will only operate in on/off
mode.
7. Please note – This switch must to the D
position for LED lighting. If left in the ON
position and LED light used there may be
damage to the control system
10