Table of Contents
Advertisement
Installing the fan
All electrical work should only be undertaken after disconnection of the power by removing
fuses or turning off the circuit breaker to ensure all pole isolation of the electrical supply.
Your fan can only be installed flush mount style, as following picture.
The following steps will guide you to a successful installation:
1. Mounting plate installation
2. Fan motor housing installation to mounting plate
3. Wiring instructions
4. Attaching the blades to the fan
5. Attaching lighting plate and glass to the fan
6. Setup remote control
1
MOUNTING PLATE installation
.
Wood screw > Spring washer > Metal round washer > mounting plate > Ceiling. Screw
the mounting plate to the ceiling and make sure all connections are secure to prevent
the fan from falling . Fixings must screw into a joist and not just the plasterboard.
The mounting plate should be screwed on to a
firm flat surface. The fixing location must be
able to withstand ten times the static weight of
the fan. If you have any doubts as to the ability
of your intended fixing location to be able to
withstand this loading, please contact our
service help-line or another competent authority
to advise you. In most situation two wood
screws screwed into a wooden joist is more than
adequate to support your ceiling fan.
The mounting plate should be screwed onto the
joist with the two wood screws provided. The
washers provided should go in the following
sequence:
5
5
Advertisement
Table of Contents
