Table of Contents
Advertisement
Quick Links
OWNERS INSTRUCTION
MANUAL
52"/132CM
Medina
Indoor & Covered Outdoor Use
INSTALLATION
OPERATION
MAINTENANCE
WARRANTY
CAUTION
READ INSTRUCTIONS CAREFULLY FOR SAFE INSTALLATION
AND FAN OPERATION. IF UNSURE CONSULT
A QUALIFIED ELECTRICIAN.
SUITABLE FOR 220-240V/50-60hz CYCLE ELECTRICAL SUPPLY
Enquiries on installing your fan please call our help line on
01959-564440
technical@fantasiaceilingfans.com
1 of 20
Advertisement
Table of Contents
Related Manuals for Fantasia Medina
Summary of Contents for Fantasia Medina
- Page 1 OWNERS INSTRUCTION MANUAL 52”/132CM Medina Indoor & Covered Outdoor Use INSTALLATION OPERATION MAINTENANCE WARRANTY CAUTION READ INSTRUCTIONS CAREFULLY FOR SAFE INSTALLATION AND FAN OPERATION. IF UNSURE CONSULT A QUALIFIED ELECTRICIAN. SUITABLE FOR 220-240V/50-60hz CYCLE ELECTRICAL SUPPLY...
-
Page 2: Safety Precautions
Safety Precautions 1. To ensure the success of the installation be sure to read the instructions and study the diagrams thoroughly before commencing. 2. All electrical work should only be undertaken after disconnection of the power by removing fuses or turning off the circuit breaker to ensure all pole isolation of the electrical supply. - Page 3 Supplied Parts One fan motor assembly One hanger bracket fitted with terminal block and top rubber washers One 6” drop rod & canopy One set of acrylic blade One set of blade carriers One boss cover ...
- Page 4 Parts names and their relative positions 4 of 20...
-
Page 5: Installing The Fan
Installing the fan All electrical work should only be undertaken after disconnection of the power by removing fuses or turning off the circuit breaker to ensure all pole isolation of the electrical supply. Your fan is a drop rod fan (Picture A) In this situation the drop rod assembly is used to lower the fan down from it’s mounting position slightly. - Page 6 2. Drop rod assembly Remove the cotter pin and split pin from the bottom of the drop rod. If a longer drop rod is going to be used transfer the ball joint to the longer rod. Put the drop rod through the flared end of the canopy and boss cover and pass the electrical supply leads from the top of the motor through the drop rod until they exit at the...
-
Page 7: Wiring Instructions
Once the drop rod assembly has been fitted, lift the fan up to the hanger bracket. Steer the ball in from the side of the bracket and lower it into the recess of the bracket. Rotate the ball around until the groove in the side of the ball aligns with the protrusion on the upper edge of the recess. - Page 8 8 of 20...
- Page 9 9 of 20...
- Page 10 10 of 20...
- Page 11 Disclaimer - This diagram is to be used as a guide. Use of this guide is at the installers risk. Fantasia Distribution Ltd accept no liability for injury, loss or damage resulting from use of this guide These colours are only for guidance and do not necessarily represent regional variance Do not connect the motor supply cable to a dimmer switch.
-
Page 12: Product Disposal Instructions
4. Adding a light kit To install an optional light kit first ensure all pole disconnection of the electricity supply. Then unscrew the three screws at the bottom of the switch housing and remove the switch housing plate. Your light fitting will either replace this plate entirely or will connect on to the plate via the push out centre stud. - Page 13 5. Assembling the blades The acrylic blades now need to be assembled on to the carrier brackets. Carefully unwrap the carrier bracket. Align the bracket with the holes in the blades and use the screws and fibre washers provided to connect them. The fibre washer should go on top the blade between the head of the screw and the surface of the blade.
-
Page 14: Blade Balancing
Operating instructions Having checked that all electrical connections are securely made and insulated, turn on the power and check the operation of the fan. The pull switch on the side of the motor housing is the selection switch for the speed function of the fan and is also the on/off function. -
Page 15: Care And Cleaning
Ensure that periodic checks of the fixings take place. (see Safety Precaution 11) Periodic cleaning of your new Fantasia fan is recommended particularly the blades. The plated or painted surfaces of your fan have been sealed with a lacquer to minimize any discoloration or tarnishing. - Page 16 Please use these pages to attach your proof of purchase as you may need it if you need to contact Fantasia in the future. Don’t forget to complete and return the warranty form at the back of this booklet. 16 of 20...
-
Page 17: Ceiling Fan Warranty
Fantasia Distribution Ltd’s repair centre. Return freight will be paid by Fantasia Distribution Ltd. The cost of obtaining or using special access equipment (scissor lifts, scaffolding etc.) is specifically excluded, and it is... - Page 18 52”/132cm Medina FANTASIA DISTRIBUTION LTD. Unit B. The Flyers Way, Westerham, Kent, TN16 1DE Tel : (01959) 564 440 Fax : (01959) 564 829 E-MAIL: info@fantasiaceilingfans.com 18 of 20...