norbar PTM-IC Series Quick Reference Manual

Advertisement

PTM-IC Series Quick Reference Guide

1. SETTING SHUT-OFF TORQUE

The torque applied by the Pneutorque® depends on the shut-off setting.
The following values need to be entered:
TOOL DISPLAY
unit
StOP
SEc
Torque applied
'StOP' limit
4% tool capacity
0
Torque units (lbf.ft / N.m)
Hi
Lo
Fin
Figure 1 – Tool Display.
Tool shuts off
Figure 2 – Typical torque application.
Part number: 34312
DESCRIPTION
High limit for torque
Low limit for torque
Shut-off torque
Reset time
Finish
Unit selected LED's (Red)
Response
Time
Issue 2
April 07
English
ON
'Hi' limit
ON
'Lo' limit
ON
Time
Tool stops

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PTM-IC Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for norbar PTM-IC Series

  • Page 1 Issue 2 April 07 Part number: 34312 English PTM-IC Series Quick Reference Guide 1. SETTING SHUT-OFF TORQUE The torque applied by the Pneutorque® depends on the shut-off setting. The following values need to be entered: TOOL DISPLAY DESCRIPTION unit Torque units (lbf.ft / N.m)
  • Page 2 NOTE: THE TOOL WILL NOT OPERATE WHILST SETTING THE SHUT-OFF TORQUE. Tip: When altering the limit settings press and hold to increase speed of change. STEP SETTING MINIMUM MAXIMUM SETTING SETTING 1.1 Power up tool. UNIT 1.2 Press ‘unit’ displayed. simultaneously.

Table of Contents