Initial Settings - Panasonic Lumix DMC-FT10EB Service Manual

3.7.2.

INITIAL SETTINGS:

After replacing the MAIN P.C.B., be sure to perform the initial settings after achieving the adjustment by ordering the following pro-
cedure in accordance with model suffix of the unit.
1. IMPORTANT NOTICE:
Before proceeding Initial settings, be sure to read the following CAUTIONS.
2. PROCEDURES:
• Precautions: Read the above "CAUTION 1" and "CAUTION 2", carefully
• Preparation:
1. Attach the Battery or AC Adaptor with a DC coupler to the unit.
2. Press the "MODE" button and set the mode to the NORMAL PICTURE mode.
Note:
If the mode select is other than NORMAL PICTURE mode, it does not display the initial settings menu.
• Step 1. The temporary cancellation of "INITIAL SETTINGS":
While keep pressing "UP of Cursor button" and iA button simultaneously, turn the Power on.
• Step 2. The cancellation of "INITIAL SETTINGS":
Press the PLAYBACK button.
Press "UP of Cursor button" and iA button simultaneously, then turn the Power off.
• Step 3. Turn the Power on:
Turn the Power on.
• Step 4. Display the "INITIAL SETTINGS" menu:
Note:
If the unit is other than NORMAL PICTURE mode, it does not display the initial settings menu.
While keep pressing MENU/SET and "RIGHT of Cursor button" simultaneously, turn the Power off.
The "INITIAL SETTINGS" menu is displayed.
There are two kinds of "NITIAL SETTINGS" menu form as follows:
[CASE 1. After replacing MAIN P.C.B.]
When MAIN P.C.B. has just been replaced, the following model suffix list is displayed as follows. (Five pages in total)
12