Panasonic Lumix DMC-FT10EB Service Manual page 51

Service Manual
Diagrams and Replacement
Parts List
Digital Camera
Model No.
DMC-FT10EB DMC-FT10GF
DMC-FT10EE DMC-FT10GN
DMC-FT10EF DMC-TS10P
DMC-FT10EG DMC-TS10PC
DMC-FT10EP DMC-TS10PU
DMC-FT10GC DMC-TS10GH
Vol. 1
Colour
(A)...........Blue Type (Except DMC-FT10EB/EE/EF/EP, DMC-TS10PC/GH)
(K)...........Black Type (Except DMC-TS10PU/GH)
(S)...........Silver Type (Except DMC-FT10EB/EE/EF/EP/GN, DMC-TS10PC/PU)
(R)...........Red Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Flash Top P.C.B. .................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. Flash Top Schematic Diagram .............................................. S-5
S5. Print Circuit Board .................................................................... S-6
S5.1. Flash Top P.C.B. .................................................................... S-6
S6. Replacement Parts List ............................................................ S-7
DSC1009053CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S7. Exploded View ....................................................................... S-11
S7.1. Frame and Casing Section.................................................. S-11
S7.2. Packing Parts and Accessories Section (1) ........................ S-12
S7.3. Packing Parts and Accessories Section (2) ........................ S-13
S-1
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram.
Name of Signal
HAVE THE SPECIAL CHARACTERISTICS