Advertisement
After replacing the Main P.C.B., be sure to achieve adjustment.
2.1.2 Initial Settings:
After replacing the Main P.C.B. and/or Flash-ROM, make sure to perform the initial settings after achieving the adjustment by ordering the
following procedure in accordance with model suffx of the unit.
1. Important Notice:
Before proceeding Initial settings, make sure to read the following CAUTION.
2. Procedures:
Precautions: Read the above "CAUTION" carefully.
Preparation:
Attach the fully charged Battery, and insert the memory card (32MB or more).
Remove the lens cap.
Step 1. The Temporary Cancellation of "Initial Settings":
Set the [ Mode dial ] to "[ P ](Program AE mode)" and [ Drive mode dial ] to "Single".
While pressing [ DISP. ] button and [ AF/AE LOCK ] button simultaneously, turn the power on.
Step 2. The Cancellation of "Initial Settings":
Press the [ Playback ] button in order to enter the [ Playback ] mode.
Press [ AF/AE LOCK ] button and "[ UP ] of Cursor buttons" simultaneously, then turn the power off.
The LCD displays the " ! " mark before the unit powers down.
Step 3. Turn the Power on:
Set the mode dial to "[ P ] (Program AE mode)", then turn the power on.
Step 4. Display the Initial Settings:
While pressing [ MENU/SET ] button and "[ RIGHT ] of Cursor buttons" simultaneously, turn the power off.
The "Initial Settings" menu is displayed.
When Main P.C.B. has just been replaced. 8 model suffxes are displayed as follows. (Two pages in total)
file:///C|/U...p/Rar$EXa0.193/viewing/SGML_VIEW_DATA/ALL/DMC-FZ1000GA/SIMP/DSC1410023AE/doc/DSC1410023AE_02.xml[11/12/2018 5:08:12 PM]
Advertisement
