Operating The System - Philips FW870C/22 User Manual

MINI HIFI SYSTEM
STANDBY
ON
CLOCK/
TIMER
CD
PROG C D 1 • 2 • 3
SEARCH • TUNING
DSC SURF
PERSONAL PAN
O
INTERACTIVE SOUND STUDIO
Important:
Before you operate the system,
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system. When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to standby
mode, the demonstration will resume 5
seconds later.
VEC
MAX
DBB
SOUND CONTROL
DISPLAY
TUNER TAPE AUX
BAND TAPE 1 • 2 CDR A.REV
STOP • CLEAR PLAY • SIDE PRESET
STROBE VEC
HOLD DBB
To stop the demonstration mode
• Press and hold STOP•CLEAR Ç (on
the system only) for 5 seconds when
the system is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" is displayed.
™ The system will switch to standby
mode.
™ About 5 seconds later, the system
will go into an energy saving mode
( < 2 watts ). The low power
STANDBY ON LED will be lit.
Note:
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold STOP•CLEAR Ç (on
the system only) for 5 seconds when
the system is in standby mode.
DOLBY B
DOLBY B
NR NR
™ The demonstration will begin.
RDS/
RDS
CD TEXT
NEWS/TA NEWS!
Easy Set
EASY SET allows you to store all available
radio stations and RDS stations
automatically.
MIC
LEVEL
MIC
1 Press and hold STANDBY•ON (on the
system only) for 5 seconds ; when the
system is in standby or demonstration
mode.
™ "EASY SET" will be displayed,
and followed by "TUNER" and then
"AUTO".
™ EASY SET will start searching for all
radio stations with RDS and then
followed by radio stations on FM,
MW and LW band respectively.
™ All available RDS and radio stations
with sufficient signal strength will be
stored. Up to 40 presets may be
stored.
2 The system will proceed to set the RDS
time automatically with the stored RDS
preset station.
• If no RDS station is available in the first
preset station, the program will exit
automatically.
™ After a radio station is found,
"EASY SET" will be displayed
and followed by "TIME"

OPERATING THE SYSTEM

• When searching RDS time;
™ "SEARCH RDS TIME" will be
displayed.
™ When RDS time is read, "RDS
TIME" will be displayed. The
current time will be displayed for 2
seconds and stored automatically.
Notes:
– EASY SET will start with the RDS
station, if there are still presets
available, it will continue to store the
FM, MW and LW bands respectively.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station or the first
available RDS station will appear on the
display when EASY SET is completed.
– If RDS station does not transmit RDS
time within 90 seconds, the program
will exit automatically and the display
will show " NO RDS TIME ".
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
11