Operating The System - Philips FW-C85 Manual

All manuals and user guides at all-guides.com
13
MINI HIFI SYSTEM
STANDBY
ON
POWER SAVE
IR SENSOR
CD 1•2•3 FM•AM
C1 • 2 • 3 BAND
CD TUNER
SEARCH•TUNING STOP•CLEAR
CLOCK/
PROG DIM
TIMER
BASS
wOOx
PLUS TECHNOLOGY
Important:
Before you operate the system,
complete the preparation
procedures.
Demonstration mode
The system has a demonstration mode
that shows the various features offered
by the system. When the system is
switched on for the first time, the
demonstration mode will start
automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to standby
or power save mode, the demonstration
will resume five seconds later.
pg 01-28/C85/37-Eng 13

OPERATING THE SYSTEM

To start the demonstration mode
• Press and hold Ç(on the system
TAPE 1•2 CDR/DVD
Easy Set
TAPE CDR AUX
PRESET
NEXT
PLAY PAUSE PREV SIDE
EASY SET allows you to store all
available radio stations automatically.
DUB
A. REV RECORD
(HSD)
• Press and hold STANDBY ON (on
TREBLE
LEVEL
To stop the demonstration mode
• Press and hold Ç(on the system
only) for five seconds when the
system is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" will be displayed.
™ The system will switch to standby
mode.
Notes:
– When the system is switched on from
the main power outlet, the CD carousel
Notes:
tray may open and close again to
– EASY SET will start with the FM band,
initialize the set.
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
– When EASY SET is used, all previously
remain off until it is switched on again.
– The last preset radio station will
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
only) for five seconds when the
system is in standby mode. You can also switch on the system by
™ The demonstration will begin.
pressing any one of the CD DIRECT
PLAY buttons.
Switching the system to
standby mode
• Press STANDBY ON or B on
the remote control.
the system only) for five seconds
™ The system will switch to standby
when the system is in standby or
mode.
demonstration mode.
™ "EASY SET" will be displayed, and
followed by "TUNER" and then Switching the system to
"AUTO".
power save mode
™ EASY SET will start searching for
Demonstration mode is stopped)
all radio stations on FM band and
• Press POWER SAVE to switch to
then followed by radio stations on
energy saving mode ( < 2 watts ).
AM band.
™ "LOW POWER STANDBY ON" will
™ All available radio stations with
be displayed, after which the
sufficient signal strength will be
display screen goes blank.
stored. Up to 40 presets may be
™ The low power STANDBY ON
stored.
LED will be lit.
Note:
– if the demonstration mode has not
if there are still presets available, the
been disabled, it will resume five
system will continue to store the AM
seconds later.
band.
stored radio stations will be replaced.
appear on the display when EASY SET
is completed.
2/16/00, 9:02 AM
(when
3139 116 19591 (ENG)