Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Philips FW870C/22
Summary of Contents for Philips FW870C/22
- Page 1 FW830C FW870C...
-
Page 2: Laser Product
Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972. Italia DICHIARAZIONE DI CONFORMITA’ Si dichiara che l’apparecchio FW830C e FW870C Philips risponde alle prescrizioni dell’art. 2 comma 1 del D.M. 28 Agosto 1995 n. 548. Fatto a Eindhoven , il 30/2/1999 Philips Consumer Electronics... - Page 3 FW830C FW870C INDEX English ...4 Français ...27 Español ...51 Deutsch ...75 Nederlands ...101 Italiano ...125 Svenska ...149 Dansk ...171 Suomi ...195 Português ...217 ∂ÏÏËÓÈο ... 241...
-
Page 5: Table Of Contents
CONTENTS GENERAL INFORMATION General Information General Information ... 5 • The typeplate (which contains the Safety Information ... 5 serial number) is located at the rear of the system. Preparation ... 6 - 7 • Recording is permissible if Controls ... 8 - 10 copyright or other rights of third parties are not infringed. -
Page 6: Preparation
PREPARATION Rear Connections STANDBY ON CUT OFF FREQUENCY H I G H P OW E R S U B WO O F E R 60Hz 150Hz AUDIO OUT DIGITAL SUB- WOOFER AUX IN FM ANTENNA 75 AM ANTENNA MAINS AUDIO IN LINE OUT FRONT –... - Page 7 A AM Loop Antenna D Line Out Connection ready) Connection You can connect the audio left and right Connect the supplied loop antenna to the LINE OUT terminals to a optional CD AM ANTENNA terminal. Place the AM loop Recorder ANALOGUE IN terminals. This antenna far away from the system and allows you to record in an analogue format.
-
Page 8: Controls
CONTROLS DISC CHANGE MINI HIFI SYSTEM STANDBY CLOCK/ TIMER PROG ⁄ º OPEN•CLOSE DISC 1 DISC 2 DISC 3 C H A N G E R SOUND CONTROL DISPLAY TUNER TAPE C D 1 • 2 • 3 BAND TAPE 1 • 2 A.REV SEARCH •... - Page 9 8 ENTER Controls on the system and – to confirm the calibration status. remote control – to store the personal equalizer band. 1 STANDBY ON – to store and confirm the personal – to switch the system on or to standby equalizer setting.
- Page 10 CONTROLS ª INTERACTIVE SOUND STUDIO › SLEEP TIMER DIGITAL SOUND CONTROL (DSC) – – to select the desired sound effect : fi B OPTIMAL, TECHNO, ROCK, CLASSIC, VOCAL or JAZZ. – PERSONAL – to select or set personal equalizer Notes for remote control: setting –...
-
Page 11: Operating The System
MINI HIFI SYSTEM STANDBY CLOCK/ TIMER TUNER TAPE PROG C D 1 • 2 • 3 BAND TAPE 1 • 2 SEARCH • TUNING STOP • CLEAR PLAY • SIDE SURF STROBE PERSONAL HOLD INTERACTIVE SOUND STUDIO Important: To stop the demonstration mode Before you operate the system, •... - Page 12 OPERATING THE SYSTEM • Rotate the JOG to select the desired Switching the system to standby mode • Press STANDBY•ON again or B on the remote control. ™ The system will switch to standby PEAK HOLD Display mode. ™ About 5 seconds later, the system will go into an energy saving mode ( <...
- Page 13 AUTO SOUND CALIBRATION (ASC) Personal Setting Whenever a new DSC or VEC feature is You can adjust the personal setting to your selected. The ASC will automatically desired level with the JOG. calibrate the new sound inorder to give a 1 Press and hold PERSONAL for about 5 smooth transition.
- Page 14 DISC CHANGE DISC 1 DISC 2 MINI HIFI SYSTEM STANDBY CLOCK/ TIMER TUNER TAPE C D 1 • 2 • 3 BAND TAPE 1 • 2 PROG SEARCH • TUNING STOP • CLEAR PLAY • SIDE SURF PERSONAL INTERACTIVE SOUND STUDIO Warning! You may load three discs in the CD 1) This system is designed for...
-
Page 15: Searching For Particular Passage During Playback
• If you press í once it will skip to the Disc Change beginning of the current track and play You can change the outer two discs while the track again. the third inner disc is stopped or is playing. 1 Press DISC CHANGE. - Page 16 Shuffle Repeat (only on remote control) In shuffle mode, the system plays all the You can play the current track, a disc or all available discs and their tracks in random available discs repeatedly. order. Shuffle may be used also when 1 Press REPEAT on the remote control tracks are programmed.
-
Page 17: Tuner
MINI HIFI SYSTEM STANDBY CLOCK/ TIMER TUNER TAPE PROG CD1 • 2 • 3 BAND TAPE 1 • 2 SEARCH • TUNING STOP • CLEAR PLAY • SIDE SURF STROBE PERSONAL HOLD INTERACTIVE SOUND STUDIO Note: • To tune to a weak radio station, briefly –... - Page 18 TUNER Note: Receiving RDS Radio Station – When you press the RDS button and the Ç RDS (Radio Data System) is a broadcasting service that allows FM stations to send additional information along with the regular FM radio signal. This additional RDS Clock information can contain: Some RDS station may be transmitting a...
-
Page 19: Tape
MINI HIFI SYSTEM STANDBY CLOCK/ TIMER TUNER TAPE PROG C D 1 • 2 • 3 BAND TAPE 1 • 2 SEARCH • TUNING STOP • CLEAR PLAY • SIDE SURF STROBE PERSONAL HOLD INTERACTIVE SOUND STUDIO Loading a tape •... -
Page 20: Aux
TAPE – C-120 tape is extremely thin and is easily deformed or damaged. It is not recommended for use in this system. – Store the tapes at room temperature and do not put them too close to a magnetic field (for example, a transformer, TV, or speaker). -
Page 21: Recording
MINI HIFI SYSTEM STANDBY CLOCK/ TIMER TUNER TAPE PROG C D 1 • 2 • 3 BAND TAPE 1 • 2 A.REV PRESET SEARCH • TUNING STOP • CLEAR PLAY • SIDE SURF STROBE PERSONAL HOLD INTERACTIVE SOUND STUDIO Notes: –... - Page 22 RECORDING – You can listen to another source while Dubbing tapes (from tape deck 1 to tape deck 2) – Dolby NR button has no influence during 1 Press TAPE ( TAPE 1•2 ) to select tape deck 2. 2 Load the prerecorded tape into tape deck 1 and a blank tape into tape deck ™...
-
Page 23: Clock
CLOCK MINI HIFI SYSTEM STANDBY CLOCK/ TIMER TUNER TAPE PROG CD1 • 2 • 3 BAND TAPE 1 • 2 SEARCH • TUNING STOP • CLEAR PLAY • SIDE SURF STROBE PERSONAL HOLD INTERACTIVE SOUND STUDIO ™ “00:00” or the current time starts Viewing the Clock flashing. -
Page 24: Sleep Timer
• After prolonged use, dirt or dust may accumulate at the CD lens. To ensure good playback quality, clean the CD lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. Cleaning the Heads and the Tape Paths •... -
Page 25: Specifications
Specifications AMPLIFIER Output power FW830C ... 2 x 200 MPO / 2 x 100 W RMS, 6 , 1 kHz, THD 10% FW870C ... 2 x 260 MPO / 2 x 130 W RMS, 6 , 1 kHz, THD 10% Signal-to-noise ratio ... -
Page 26: Troubleshooting
TROUBLESHOOTING Warning! Under no circumstances Radio Reception you should try to repair the set yourself Poor radio reception as this will invalidate the guarantee. • The signal is too weak. Do not open the set as there is a risk of ™...