LION SERIES
Control Element
REAR PANEL
1
2
1- Channel A Link out
2- Channel A XLR/TRS Input
This XLR/TRS jack will accept any balanced or unbalanced low impedance line level source
by means of a three-pin XLR/TRS plug. The wiring for the plug is as follows:
Pin1(Sleeve)=Ground, Pin2(TIP)=Signal+, Pin3(Ring)=Signal-.
3- Channel B TRS/XLR Input
This XLR/TRS jack will accept any balanced or unbalanced low impedance line level source
by means of a three-pin XLR/TRS plug. The wiring for the plug is as follows:
Pin1(Sleeve)=Ground, Pin2(TIP)=Signal+, Pin3(Ring)=Signal-.
4- Channel B Link out
5- SUB-X-OVER FREQ
Cut off frequency selectors for low-pass (SUB) filters, the value can be set from 50Hz to
250Hz.
X-OVER FREQ is available in Mode 4(SUB-Stereo) only.
6- MODE
Mode 1: CHA/CHB stereo
Input and output channels are independent.
Mode 2: CHA/CHB parallel
Outputs are the same with any channel input.
Mode 3: NC - Not used
Mode 4: CHA/CHB sub-Stereo
CHA and CHB are stereo,output signal is low frequency, X-over FREQ
CHA/CHB is available.
3
4
5
6
7
8
- 6 -
9