Plugging The Board Into The Slot; Closing The Pc; Fig. 5-3: Inserting The Board; Fig. 5-4: Fastening The Board At The Back Cover - Addi-Data ADDICOM APCI-7501 Technical Description

Technical description
5.1.3

Plugging the board into the slot

Discharge yourself from electrostatic charges.
• • • •
Insert the board vertically into the chosen slot.
• • • •
Fasten the board to the rear of the PC housing with the screw
•
which was fixed on the back cover.

Fig. 5-4: Fastening the board at the back cover

Tighten all the loosen screws.
• • • •
5.1.4

Closing the PC

Close your PC as described in the manual of the PC manufacturer.
•
Chapter 5

Fig. 5-3: Inserting the board

APCI-7501
11