Table of Contents
Advertisement
Technical description
5
INSTALLATION
The interrupt line and the base address of the board are set per software through
the BIOS of the PC system. Therefore, there are no settings to be made before
inserting the board.
IMPORTANT!
If you want to install simultaneously several ADDI-DATA boards,
consider the following procedure.
Install and configure the boards one after the other.
•
You will thus avoid configuration errors.
1. Switch off the PC
2. Install the first board
3. Start the PC
4. Install the software (only once)
5. Configure the board
6. Switch off the PC
7. Install the second board
8. Start the PC
9. Configure the board
etc
You will find additional information to these different steps in the sections 5.1
to 5.4.
IMPORTANT!
You have installed already one or more ADDI-DATA boards in your
PC, and you wish to install an additional board?
Proceed as if you wished to install one single board.
Chapter 5
APCI-7501
9
Advertisement
Table of Contents
