Table of Contents
Advertisement
CD
Selecting a desired track
Selecting a desired track when
playback is stopped
1 Press S or T (or í / ë on
the remote control) until the desired
track appears on the display.
2 Press PLAY É to start playback.
™ The selected track number and
elapsed playing time appear on the
display.
Selecting a desired track during
playback
• Press S or T (less than 0.5
seconds) until the desired track appears
on the display.
™ The selected track number and
elapsed playing time appear on the
display.
• If you press S (less than 0.5
seconds) it will skip to the beginning of
the current track and play the track
again.
Searching for a particular
passage during playback
• Press and hold SEARCH S or
T (or à / á on the remote
control) until the desired passage is
located.
™ The volume will be reduced.
• Play returns to normal when SEARCH
S or T is released.
14
Programming Tracks
Programming tracks of a loaded CD is
possible when playback is stopped. The
display will indicate the total tracks stored
in the program. Up to 40 tracks can be
stored in the memory in any order. When
40 tracks are stored and you attempt to
store another track, the display will show
"FULL".
1 Load the desired discs in the disc trays.
2 Press PROGRAM to start programming.
™ The
flag starts flashing.
PROGRAM
™ It will cancel any previously selected
repeat mode.
3 Press the 3 CDC button to select the
disc.
4 Press S or T (or í / ë on
the remote control) to select the desired
track.
5 Press PROGRAM to store the track.
• Repeat steps 3 to 5 to store other discs
and tracks.
6 Press STOP once to end programming.
™ The total number of tracks
programmed and total playing time
appear on the display.
Notes:
– If the total playing time is more than
" 99:59 " or if one of the programmed
tracks has a number greater than 30,
then " --:-- " appears on the display
instead of the total playing time.
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Reviewing the program
Reviewing of the program is possible only
when playback is stopped.
• Press S or T repeatedly to
review the programmed tracks.
• Press STOP to exit review mode.
Playing the program
1 Press PLAY É to start program
playback.
™ "PLAY PROGRAM" appears on
the display.
™ The track number and elapsed
playing time of the current track will
appear on the display.
• If you press REPEAT during program
playback, the current track or all
programmed tracks will be played
repeatedly.
™ "TRACK" or "PROGRAM" will be
displayed.
™ The
and
flags will be
REPEAT
PROGRAM
displayed.
2 Press STOP to stop program playback.
Notes:
– If you press any of the CD DIRECT PLAY
buttons, the system will play the
selected disc or track and the stored
program will be ignored temporarily. The
PROGRAM flag also will disappear
temporarily from the display. It will
reappear when playback of the selected
disc ends.
– REPEAT DISC mode will be cancelled
when program playback begins.
Erasing the program
(when
playback is stopped)
• Press STOP.
™ "PROGRAM CLEARED" will be
displayed.
Note:
– The program will be erased when the
system is disconnected from the power
supply or when the CD carousel is
opened. If the CD carousel is opened,
the tracks belonging to the outer two
trays will be erased and the display will
show " TRACKS CLEARED ".
3139 116 19161
Hide quick links:
Advertisement
Table of Contents
