Disc Change; Reviewing The Program; Selecting A Desired Track - Philips FW-C380 User Manual

Mini hi-fi system
Hide thumbs Also See for FW-C380:
Table of Contents

Advertisement

17

Disc Change

You can change the outer two discs
while the third inner disc is stopped or
is playing.
1
Press DISC CHANGE.
The CD changer tray slides out.
2
Replace the discs in the left and right
disc trays.
¶ If you wish to change the inner disc
during playback, press DISC
CHANGE again.
"DISC CHANGE" will be
displayed.
The disc will stop playing.
The CD changer tray will close to
retrieve the inner disc and then
open again with the inner disc
accessible.
3
Press OPEN•CLOSE to close the
CD changer tray.

Selecting a desired track

Selecting a desired track when
playback is stopped
1
Press í or ë until the desired
track appears on the display.
2
Press PLAYÉ Å to start playback.
The selected track number and
elapsed playing time appear on
the display.
pg 01-30/C380/37-En
Selecting a desired track during
playback
¶ Press í or ë until the desired
track appears on the display.
The selected track number and
elapsed playing time appear on
the display.
¶ If you press í once it will skip to
the beginning of the current track
and play the track again.
Note:
– Pressing í during shuffling can only
skip to the beginning of the current
track.
Searching for a particular
passage during playback
¶ Press and hold à or á until the
desired passage is located.
The volume will be reduced.
¶ Play returns to normal when à or
á is released.
17
CD
Programming Tracks
Programming tracks of a loaded disc is
possible when playback is stopped. The
display will indicate the total tracks
stored in the program. Up to 40 tracks
can be stored in the memory in any
order. When 40 tracks are stored and
you attempt to store another track, the
display will show "FULL".
1
Load the desired discs in the disc
trays.
2
Press PROGRAM to start
programming.
The PROG flag starts flashing.
3
Press the CD (CD 1•2•3) or DISC
1/2/3 button to select the disc.
4
Pressí or ë to select the desired
track.
5
Press PROGRAM to store the
track.
¶ Repeat steps 3 to 5 to store other
discs and tracks.
6
Press Ç once to end programming.
The total number of tracks
programmed and total playing
time appear on the display.
12/6/00, 2:21 PM
Notes:
– If the total playing time is more than
"99:59" or if one of the programmed
tracks has a number greater than 30,
then "--:--" appears on the display
instead of the total playing time.
– If the system is reading the discs,
programming is not possible,
"READING" will be displayed and
followed by "DISC X". "X" is the
current read disc number.
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
– "SELECT A DISC" will be displayed
when programming an empty disc slot.

Reviewing the program

Reviewing of the program is possible
only when playback is stopped.
¶ Pressí or ë repeatedly to review
the programmed tracks.
¶ Press Ç to exit review mode.
3139 115 20462 (ENG)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents