Disc Operations
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
IMPORTANT!
It is only possible to programme from
the current selected disc tray.
1
1
Load the desired discs into the disc trays (refer
to "Loading discs").
2
Press CD or one of the CD 1~3 buttons to
select a disc.
3
Press PROGRAM to start programming.
➜
starts flashing.
PROG
4
Press – or + (or í/ë on the remote control)
repeatedly to select the desired track.
●
For MP3 discs, press 4 or ¢ (or 1 / ¡
on the remote control) and – or + (or í/ë
on the remote control) to select the desired
album and title for programming.
5
Press PROGRAM to store.
●
Repeat steps 4–5 to select other tracks.
➜
If you attempt to programme more than 99
tracks, "PROGRAM FULL" is displayed.
6
To start programme play, press É Å .
7
To stop playback or to end the programming,
press Ç once.
➜
stays and the programme mode
PROG
remains active.
Notes:
– If the total playing time has reached 100
minutes or one of the programmed tracks has a
number greater than 30, "—:—" is displayed
instead of the total playing time.
– The system will exit programming mode if no
button is pressed within 20 seconds.
18
Checking the programme
1
Stop playback and press – or + (or í/ë on
the remote control) repeatedly.
2
Press Ç to exit.
OR
Press É Å to start playback from the current
programmed track
Clearing the programme
2
●
Stop playback, then press Ç to clear the
program.
4
➜
PROG
6
is displayed.
7
Note:
3
5
– The programme will be erased if the system is
disconnected from the power supply or you switch
to another source mode.
disappears and "PROGRAM CLEARED"