Sighting The Scanner - Chentronics iS3-MB Manual

TOLERANCE NOTES
FABRICATED TOLERANCES
≥ 2 ft (610 mm) ± 0.250 in (6.4 mm)
< 2ft (610 mm) ± 0.125 in (3.2 mm)
MACHINED TOLERANCES
± 0.050 DECIMAL DIM (1 PLACE)
± 0.010 DECIMAL DIM (2 PLACES)
± 0.005 DECIMAL DIM (3 PLACES)

Sighting the Scanner

Failure to sight the scanner properly can cause an explosion.
and serviced by qualified personnel in accordance with applicable local and national codes,
standards, and ordinances.
N'ouvrez pas le capot de l'équipement et ne le réparez pas si une atmosphère
explosive peut être présente. L'équipement doit être installé et entretenu par du
personnel qualifié conformément aux codes, normes et ordonnances locales et
nationales applicables
Proper sighting of the flame is required for proper flame scanner detection and discrimination.
The view through the sighting port should be full flame, as illustrated below.
RELATED DOCUMENT – MUST COMPLY WITH SCHEDULE DOCUMENT(S):
FOR A LIST OF RELEVANT PATENTS
AND TRADEMARKS PLEASE SEE
CHENTRONICS.COM/LEGAL-NOTICES
ISO 9001 CERTIFIED
DRAWN BY:
ON:
AR
7/8/19
LAST REV BY: ON:
MNL-ISCAN3
EXPLOSION HAZARD
TENSION DANGEREUSE
CORRECT
ISCAN3 MANUAL
DCO No
.
12804
DWG. No.
This
MNL-ISCAN3
THIS DRAWING OWNED BY
CONDITIONALLY LOANED AND IS TO BE RETURNED UPON
REQUEST. THE BORROWER BY RECEIVING IT HAS AGREED
NOT TO REPRODUCE NOR COPY IT IN WHOLE OR IN PART
NOR TO FURNISH INFORMATION FROM IT TO OTHERS NOR
TO MAKE ANY USE OF IT THAT IS OR MAY BE INJURIOUS TO
CHENTRONICS. FOR MORE INFORMATION PLEASE CONTACT
CHENTRONICS AT +1.607.334.5531.
Equipment must be installed
INCORRECT
CERT-iS3 MNL
PAGE 25 OF 28
C
REV.
CHENTRONICS. IT IS