Ecco Reflex 5500 Series Installation And Operation Instructions

5500 Series - Reflex™ LED Minibars provide a compact yet
powerful warning solution that offers the flexibility of either
permanent or vacuum-magnet mounting. The 5500 Series
features 12-24 VDC operation, uses reflector technology
to maximize light output, and offers multiple flash patterns
including double, quad, quint, rotate and random.
IMPORTANT! Read all instructions before installing and using. Installer: This manual must be delivered to the end user.
Failure to install or use this product according to manufacturers recommendations may result in property damage,
serious injury, and/or death to those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understand the
safety information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices
are essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that
s/he can operate the system without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use,
the vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open
trunks or compartment doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffic, responding at a high rate of speed, walking on or around traffic lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying
all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws
and regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.

Specifications:

Size: 5565 A VA1, 5565 CA VA1
5565 A VA2, 5565 CA VA2
5565 A VAMAG, 5565 CA VAMAG 380 x 229 x 79mm
Weight: Permanent mount
Vacuum-Magnet Mount
Input Voltage: 12 to 24 VDC systems
Page 1 of 4
P/N 920-0323-00 (Rev B) 2018-07-17
© 2018 at Electronic Controls Company
Installation and Operation Instructions
380 x 229 x 63.5mm
380 x 229 x 63.5mm
approx. 1.5kg (3.4 lbs).
approx. 2.6kg (5.7 lbs).
5500 Series LED Minibars
Current Draw:
2.7 Amps Maximum
Maximum power consumption: 35 watts
Output Power(total):
600 Candela Seconds Maximum
Temp. Range: -30ºC to +50ºC