Ecco Vantage 12 Series Installation And Operation Instructions

IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be
delivered to the end user. This manual assumes installation by a suitably qualifi ed Automotive Technician.
!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understand the safety
information contained in this manual.
1. Proper installation combined with operator training in the use, care and maintenance of emergency warning devices are essential to
ensure the safety of emergency personnel and the public.
2. Emergency warning devices often require high electrical voltages and/or currents. Exercise caution when working with live electrical
connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current
arcing, which can cause personal injury and/or severe vehicle damage, including fi re.
4. Proper placement and installation is vital to the performance of this warning device. Install this product so that output performance of
the system is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system
without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure daily that all features of this product work correctly. In use, the vehicle operator
should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks or compartment doors),
people, vehicles or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to an emergency warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an intersection, drive
against traffi c, respond at a high rate of speed, or walk on or around traffi c lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws
regarding emergency warning devices. Therefore, the user should check all applicable city, state, and federal laws and regulations.
The manufacturer assumes no liability for any loss resulting from the use of this warning device.
8. This product may contain high intensity LEDs staring directly into these lights could result in temporary and/or permanent vision
impairment.
CAUTION!
Disconnect the battery before wiring up the lightbar, to prevent accidental shorting, arcing and/or electrical shock.
920-0332-00 Rev. B
Installation and Operation Instructions
12 Series Vantage™ Lightbars Accessories
25A
Ignition
Switch
Controller
(Optional)
Batt +
Pattern 1 (Brown)
Pattern 2 (Orange)
Alley Left (Yellow)
Alley Right (Green)
Worklight (Blue)
Pattern Sel (Violet)
2A Mom
RED Power Cable
12-SERIES LIGHTBAR
Control Cable
S/T/T Cable
BLK
Adapter
OR
(Supplied)
(Brown) Tail
(Yellow) Left
(Green) Right
(White) Ground
(Red) N/C
Page 1 of 5