Table of Contents
Advertisement
Clock/Timer
DISPLAY/BAND
Clock setting
Manual clock setting
1
In standby mode, press and hold
CLOCK SET.
The clock digits for the hours flash.
2
Adjust VOLUME to set the hours.
3
Press CLOCK SET again.
The clock digits for the minutes flash.
4
Adjust VOLUME to set the minutes.
5
Press CLOCK SET to confirm the time.
Timer setting
The system can be used as an alarm clock,
whereby the CD, TUNER or TAPE is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
You can also use it to record a favourite tuner
programme at a set period (refer to "Recording
timer")
During setting, if no button is pressed within 90
seconds, the system will exit timer setting mode
automatically.
18
1
In standby mode, press PRESET 3 for more
than two seconds.
2
Press SOURCE repeatedly to select the sound
source.
"SET TIME" and "SELECT SOURCE" are
displayed.
3
Press PRESET 3 to confirm your desired
mode.
"SET ON TIME" is displayed and the clock
digits for the hours flash.
4
Adjust VOLUME to set the hours.
5
Press PRESET 3 again.
The clock digits for the minutes flash.
6
Adjust VOLUME to set the minutes.
7
Press PRESET 3 to confirm the time.
The timer is now set and activated.
Activating and deactivating timer
In standby or during playback, press TIMER
once on the remote control.
Display shows
deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
The selections are as follows (time in
minutes):
60 ™ 45
45 ™ 30
30 ™ 15
60
60
60
60
45
45
45
30
30
30
"SLEEP XX" or "0" is displayed. "XX" is the
time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
To deactivate the sleep timer
Press SLEEP repeatedly until "0" is displayed, or
press the STANDBY ON button.
if activated, and disappears if
15 ™ 0 0 0 0 0 ™ 60
15
15
15
60
60
60 ...
60
Advertisement
Table of Contents
