Page 3
Name und Anschrift des Herstellers Name und Anschrift seines in der EU Name and address of the manufacturer: niedergelassenen Bevollmächtigten his authorised representative in EU Rotary Lift BlitzRotary GmbH 2700 Lanier Drive Hüfinger Str.55 Madison, IN, 47250 USA 78199 Bräunlingen, Germany Diese Erklärung bezieht sich nur auf die Maschine in dem Zustand, in dem sie in Verkehr gebracht wurde;...
Page 4
Only those technicians who have been properly trained in the usage and care of the lift should be allowed to operate the lift. Local regulations MAY require that the trained operator be at least 18 years of age or be supervised by a trained operator while: A.
OPERATING INSTRUCTIONS SURFACE MOUNTED FRAME ENGAGING LIFTS WARNING To avoid personal injury and/or property damage, permit only trained personnel to operate lift. After reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. IMPORTANT Always lift the vehicle using all four adapters.
Page 8
6. To Lower Lift: • Raise vehicle until tires clear the floor. • Remain clear of lift when lowering vehicle. Keep Feet Clear! • Stop and check adapters for secure contact at vehicle • For M Series Lifts, Fig. 1: manufacturer’s recommended lift points.
Typical Lift Points Positioning the Vehicle Truck Frame For longer wheel base vehicles, position the vehicle on the forward spotting dish. For shorter wheel bases, position the Lift Adapter vehicle on the rear spotting dish. Due to varying centers of gravity within different vehicle classes, use the dishes as guides only and locate the arms beneath the vehicle pickup points.
• Replace all decals on the lift if unable to read or missing. • Daily: Inspect adapters for damage or excessive wear. If Reorder labels from Rotary Lift. parts are worn, call local service representative. • Monthly: Clean and check base of lift. Remove any rust and •...
Page 11
TROUBLE SHOOTING FOR OPERATORS FOR E SERIES LIFTS button actuated but lift doesn't raise Trouble Cause Remedy Motor won't run. 1. Overhead Sensor Actuated. 1. Check sensor for contact with vehicle. 2. Up button not functioning. 2. Check UP button on opposite column if neither UP button is functioning contact service representative for further assistance.
MAINTENANCE AUTHORIZED BY QUALIFIED SERVICE REPRESENTATIVE ONLY • Lockout all energy sources before beginning any repairs. • Replace worn parts as required with Rotary Genuine Parts. • DO NOT modify the lift in any manner without the prior • Adjust equalizer cable tension per lift installation written consent of the manufacturer.
Page 13
TROUBLE SHOOTING (FOR AUTHORIZED MAINTENANCE PERSONNEL) Trouble Cause Remedy Motor does not run. 1. Incorrect voltage to motor. 1. Supply correct voltage to motor. 2. Bad wiring connections. 2. Repair and insulate all connections. 3. Motor up switch burned out. 3.
EQUALIZER CABLE ADJUSTMENT Checking and Adjusting Equalizer Cables: Raise lift to check equalizer cable tension. Below carriage, grasp adjacent cables between thumb and forefinger, with about 67N effort you should just pull the cables together. Adjust at upper tie-offs (Fig. 4). Fig.
11. If your facility power was not lost have a certified electrican Raise lift off of the locking latch. You should only have to raise check wiring to lift or call an authorized Rotary repair person. lift approximately 1/4" to disengage the lock.
Need help?
Do you have a question about the 200 Series and is the answer not in the manual?
Questions and answers