Dakota Alert PR-1000 Instructions

PR-1000 PoRtable ReCeiveR inStRuCtionS
WARNING: This device complies with Part 15 of the FCC rules, Operation of this device is subject to the following conditions: 1. This device may not cause
harmful interference. 2. This device must accept any interference, including interference that may cause undesired operation.
PaRtS & FunCtion
PoweR
1. Slide to open the battery
cover.
2. Insert 2 AA batteries.
3. Close the battery cover.
PORTABLE RECEIVER.indd 1
Contact dakota alert:
32556 e Main St.
elk Point, Sd 57025
ph: 605.356.2772
www.dakotaalert.com
Mounting
Hang on wall or clip on belt.
Code MatChing & tone SeleCtion
entering learning mode
Press and hold the 'Learning'
button for 3 seconds. The LED
#1 will flash indicating that zone
1 is ready to be programmed.
To program zones 2-4, press the
Melody
'Learning' button again to cycle
selector
through each zone. Press the
'Melody' button to select one of
18 melodies/tones. Activate the
transmitter to learn the new code.
After selecting the zone and melody, activate the transmitter once. If the
coding is successful, the chime will generate a short tone.
If another LED lights up, this remote button is already programmed on
the zone that lights up.
The Siren sound is intended for use as a panic button and will sound for
one minute.
delete the transmitter on the chime memory
Enter the learning mode by pressing and holding the 'Learning' button
for 3 seconds. Press the 'Learning' button to select the zone you want to
delete. Press and hold both the 'Leaning' button and the 'Melody' but-
tons 3 seconds. The chime will generate a tone to indicate the remote on
this zone has been deleted.
Change the melody/tone on desired zone
Enter the learning mode by pressing and holding the 'Learning' button
for 3 seconds. Press the 'Learning' button to select the zone you want to
change. Press the 'Melody' button to select the new melody/tone and
then activate the transmitter for the selected zone. You will hear a tone
to indicate the melody has been changed.
Reset button
Pressing the 'Reset' button will stop the chime and light after the unit has
been activated.
Learning
button
10/17/2013 9:01:53 AM